Setting Up Touch Pilot Control; General Description; Welcome Screen; Synoptic Screen - Carrier Touch Pilot Control Series Control Manual

6 - SETTING UP TOUCH PILOT CONTROL

6.1 - General description

Touch Pilot includes the 7 in. touch screen allowing for easy system
control. Navigation through the Touch Pilot control is either using
the touch screen interface or by connecting to the web interface.
The navigation menus are the same for both connection methods
(Touch Pilot user interface and web browser). It is recommended
to use a stylus pen for the navigation via the touch screen.
NOTE: Some functions are unavailable when using the web
browser interface.
The Touch Pilot interface includes the following screens:

- Welcome screen

- Synoptic screen

- Operating mode selection screen
- Data/configuration screens
- Password entry and language selection screen
- Alarms screen
- Parameter modification screen
6.2 - Welcome screen
The Welcome screen is the first screen shown after starting the
user interface. It displays the application name as well as the
current software version number.
To exit the Welcome screen and go to the Home screen
(see section 6.3), press the Home
(1)
Legend
1. Home button
2. Software version number
3. Information message box
Information message box: The information displayed in the status
bar at the bottom of the screen includes relevant messages
regarding the current user action.
Message Status
COMMUNICATION Equipment controller did not respond while
FAILURE! reading the table content.
Equipment controller denies access to one of
ACCESS DENIED!
the tables.
LIMIT EXCEEDED! The value entered exceeds the parameter limit.
Modifications have been made. The exit must
Save changes?
be confirmed by pressing "Save" or "Cancel".
HIGHER FORCE IN Equipment controller rejects Force or Auto
EFFECT! command.
Too many users
Too many users connected at the same time
connected ! Please
(WEB INTERFACE ONLY)
try again later ...
button.
(2)
(3)
6.3 - Synoptic screen
The Synoptic screen allows you to monitor the vapour-refrigeration
cycle. The diagram indicates the current status of the unit, giving
information on the unit capacity, the status of water heat exchanger
pumps, and the pre-defined setpoint parameter.
All unit functions can be accessed by pressing the Main menu
button.
(1) (2)
(6)
(10)
(7)
Example: Synoptic view. This picture is for information only.
It may differ from the actual look, depending on pumps and OAT sensor availability.
Legend
1. Home button
2. Main menu button
3. Login button (restricted access to menus)
4. Start/Stop button
5. Alarm button
6. Compressor + unit capacity
7. LWT and EWT (condenser)
8. Setpoint
9. Unit running status
10. LWT and EWT (evaporator)

6.4 - Unit start/stop

With the unit in the Local off mode:
• To display the list of operating modes and select the required
mode, press the Start/Stop button in the upper-right corner
of the Synoptic screen.
IMPORTANT: When entering the menu, please note that the
currently selected item corresponds to the last running
operating mode.
(3) (4) (5)
(8)
(9)
11