Seat Ateca 2016 Owner's Manual page 247

The ultrasound sensors have blind spots in
●
which obstacles and people are not regis-
tered. Pay special attention to children and
animals.
Always keep visual control of the vehicle
●
surroundings: use the mirrors for additional
help.
CAUTION
Parking Aid functions may be negatively af-
fected by different factors that may lead to
damage to the vehicle or its immediate sur-
rounds:
Under certain circumstances, the system
●
does not detect or display certain objects:
Objects such as chains, trailer draw bars,
–
fences, posts and thin trees.
Objects that are located above the sen-
–
sors, such as protrusions in a wall.
Objects with certain surfaces or struc-
–
tures, such as wire mesh fences or pow-
der snow.
● Certain surfaces of objects and garments
do not reflect the ultrasound sensors' sig-
nals. The system cannot detect these objects
or people wearing such clothes correctly.
● Ultrasound sensor signals may be affected
by external sound sources. In certain circum-
stances this may prevent them from detect-
ing people or objects.
Please note that low obstacles detected by
●
the system may no longer be registered by
Driver assistance systems
the sensors as the car moves closer, so the
system will not give any further warning. In
certain circumstances, objects such as high
kerbs that could damage the bottom of the
vehicle are not detected either.
● If the first warning from the ParkPilot is ig-
nored, the vehicle could suffer considerable
damage.
● The knocks or damage on the radiator
grille, bumper, wheel arch and vehicle under-
body can adjust the orientation of the sen-
sors. This can affect the parking aid function.
In this case, have the function checked by a
specialised workshop.
Note
● In certain situations, the system can give a
warning even though there is no obstacle in
the detected area, e.g:
with rough or cobbled floors or ground
–
with long grass;
with external ultrasound sources, such as
–
cleaning vehicles or other vehicles equip-
ped with ultrasound systems;
in downpours, intense snow, hail or
–
dense exhaust gases,
if the number plate is not perfectly se-
–
cured to the bumper surface,
or in locations such as the brow of a hill.
–
In order to guarantee good system opera-
●
tion, keep the ultrasound sensors clean, free
of snow or ice, and do not cover them with
adhesives or other objects.
● If you use high-pressure or vapour equip-
ment to clean the ultrasound sensors, apply
it directly only very briefly and always from a
distance of more than 10 cm.
Retrofitting of accessories to the vehicle,
●
such as a bicycle rack, may interfere with the
operation of the Parking Aid.
In order to familiarise yourself with the sys-
●
tem, it is advised that you practice parking in
an area or car park that is free from traffic.
There must be good weather and light condi-
tions.
The volume and tone of the warnings can
●
be modified, in addition to the indications
›››
page 246.
In vehicles without an infotainment system,
●
these parameters can be modified in a SEAT
Official Service or in a specialised workshop.
Please observe information on towing a
●
›››
trailer page 247.
● The display on the Easy Connect screen
shows a slight time delay.
Parking Aid operation
Manual disconnection of Parking Aid display
(the audible sounds remain active)
● Press a button on the main menu of the fac-
tory-assembled infotainment system.
● OR: Press the BACK function button.
»
245