Seat Functions - Seat Ateca 2016 Owner's Manual

Adjusting the head restraints
To set the head restraint higher, grasp the
–
sides with both hands and move it up-
wards, until you see it engage.
To set the head restraint lower down, press
–
›››
Fig. 141
the button and move it
1
downwards.
Removing the head restraint
To remove the head restraint, the correspond-
ing backrest must be partially folded forward.
›››
Unlock the backrest
–
Move the head restraint upwards until it ar-
–
rives to the top.
›››
Press button Fig.
–
1
neously pressing on the security hole
›››
Fig. 141 with a flat screwdriver a maxi-
mum of 5 mm wide, and remove the head
restraint.
Move the backrest until it engages properly
–
›››
.
Fitting the head restraint
To mount the external head restraints, the
corresponding backrest must be partially fol-
ded forward.
›››
Unlock the backrest
–
Insert the head restraint bars into the
–
guides until they perceptibly engage. It
144
should not be possible to remove the head
restraint from the backrest.
Move the backrest until it engages properly
–
›››
WARNING
● Please observe the general notes
›››
page
Remove the rear head restraints only when
●
it is necessary for the placement of a child
›››
seat
remount the head restraint immediately.
page 146. Travelling with the head restraints removed
or improperly adjusted increases the risk of
severe injuries.
141, while simulta-
2

Seat functions

Introduction
WARNING
Inappropriate use of the seat functions can
cause severe injuries.
● Assume the proper sitting position before
your trip and remain in it throughout. This al-
so applies to the other occupants.
Always keep hands, fingers, feet and other
●
page 146.
parts of the body away from the operating ra-
dius and the adjustment of seats.
Operation
.
66.
page 79. After removing a child seat,
Seat heating
Fig. 142 In the centre console: front seats
heating switch
The seat cushions can be heated electrically
when the ignition is switched on. The back-
rest is also heated in some versions.
The seat heating should not be engaged in
any of the following conditions:
● The seat is unoccupied.
● The seat has a covering.
● There is a child seat installed in the seat.
● The seat cushion is wet or damp.
● The indoor or outdoor temperature is great-
er than 25°C (77°F).
Activate
Press the button  or . Seat heating is
switched on fully.