Seat Ateca 2016 Owner's Manual page 235

with the operation of the Park Assist system
and cause damage.
● The Park Assist system uses as a reference
parked vehicles, curbs and other objects.
Make sure that the tyres and wheels are not
damaged while parking. If necessary, oppor-
tunely interrupt the parking manoeuvre to
avoid damaging the vehicle.
● The ultrasound sensors on the bumper may
be damaged or shifted in the event of a colli-
sion, for example, when entering or exiting a
parking space.
If you use high-pressure or vapour equip-
●
ment to clean the ultrasound sensors, do not
apply it directly unless very briefly and al-
ways from a distance of more than 10 cm.
● A registration plate or plate holder on the
front with larger than the space for the regis-
tration plate, or a registration plate that is
curved or warped can cause:
false detections,
–
loss of sensor visibility,
–
cancellation of the parking manoeuvre or
–
defective parking.
● If one of the ultrasonic sensors is damaged,
the area corresponding to that group of sen-
sors (front or rear) is deactivated and cannot
be activated until the fault is corrected. How-
ever, you can still use the sensors of the oth-
er bumper as per usual. If there is a fault in
the system, consult a specialist workshop.
SEAT recommends visiting a SEAT dealership
for this.
Driver assistance systems
Note
● In order to guarantee good system opera-
tion, keep the ultrasound sensors of the
bumper clean, free of snow or ice, and do not
cover them with adhesives or other objects.
Certain sources of noise, such as rough as-
●
phalt or paving stones and the noise of other
vehicles can induce the Park Assist system or
ParkPilot to give erroneous warnings.
● In order to become familiar with the system
and its functions, SEAT recommends that you
practice operating the Park Assist system in
an area where there is not too much traffic or
in a car park.
Description of the Park Assist system
At the top of the centre console: but-
Fig. 200
ton to switch on the Park Assist system.
The components of Park Assist system are
the ultrasonic sensors located in the front
›››
and rear bumpers, the Fig. 200

to switch the system on and off and the mes-
sages on the instrument panel display.
Prematurely stopping or automatically inter-
rupting the manoeuvres for parking or exit-
ing a parking space
Park Assist interrupts the manoeuvres for
parking or exiting a parking space in any of
the following cases:
Button is pressed.
●

● The speed exceeds approximately 7 km/h
(4 mph).
● The driver takes hold of the steering wheel.
The parking manoeuvre does not end with-
●
in approximately 6 minutes following activa-
tion of the automatic steering.
● There is a fault in the system (the system is
temporarily unavailable).
● ASR is switched off.
● ASR or ESC intervene with regulation.
● The driver door is opened.
To restart the manoeuvre it is necessary that
none of these things occur and that button
is pressed again.

button
»
233