Seat Ateca 2016 Owner's Manual page 107

Identifying letters on engine (MKB)
›››
Hold the button Fig. 115
4
than 15 seconds to display the identifying
letters of the vehicle engine (MKB). To do
this, the ignition must be switched on and
the engine switched off.
WARNING
›››
Observe the safety warnings
and control lamps on page 107.
WARNING
Even though outside temperatures are above
freezing, some roads and bridges may be icy.
● At outside temperatures above +4°C
(+39°F), even when the "ice crystal" symbol
is not visible, there may still be patches of ice
on the road.
Do not rely on the outside temperature in-
●
dicator!
Note
Different versions of the instrument panel
●
are available and therefore the versions and
instructions on the display may vary. In the
case of displays without warning or informa-
tion texts, faults are indicated exclusively by
the warning lamps.
Depending on the equipment, some set-
●
tings and instructions can also be carried out
in the Easy Connect system.
Instruments and warning/control lamps
When several warnings are active at the
●
same time, the symbols are shown succes-
down for more
sively for a few seconds and will stay on until
the fault is rectified.
Odometer
in Warning
Fig. 116 Instrument panel: odometer and re-
set button.
The distance covered is displayed in "kilome-
tres" or miles "m". It is possible to change
the measurement units (kilometres
"km"/miles "m") in the radio/Easy Connect*.
Please refer to the Easy Connect* Instructions
Manual for more details.
Odometer/trip recorder
The odometer shows the total distance cov-
ered by the vehicle.
The trip recorder shows the distance that has
been travelled since it was last reset. It is
used to measure short trips. The last digit of
the trip recorder indicates distances of 100
metres or tenths of a mile.
The trip recorder can be set to zero by press-
›››
ing Fig. 116.
0.0/SET
Fault display
If there is a fault in the instrument panel, the
letters will appear in the trip recorder
DEF
display. Have the fault repaired immediately,
as far as is possible.
Coolant temperature gauge
For vehicles with no coolant temperature
gauge, a control lamp appears for high

›››
page 286. Please
coolant temperatures
›››
note .
The coolant temperature gauge
›››
Fig. 115 only works when the ignition is
switched on. In order to avoid engine dam-
age, please read the following notes for the
different temperature ranges.
Engine cold
If only the diodes in the lower part of the
scale light up, this indicates that the engine
has not yet reached operating temperature.
Avoid high revs and heavy acceleration and
do not make the engine work hard.
2
»
105