Seat Ateca 2016 Owner's Manual page 21

Weight group
Group 0 to 10 kg
Group 0+ to 13 kg
Group I 9 to 18 kg
Group II 15 to 25 kg
Group III 22 to 36 kg
a) Compliance with current national legislation and the manufacturer's instructions is required when using or installing child seats.
b) For semi-universal chairs where the securing system is the car safety belt and the support bracket, do not use them in the centre rear seat.
X: It is not compatible to install chairs in
this configuration.
U: Suitable for universal restraint systems
for use in this weight group.
UF: Acceptable for front-facing universal-cat-
egory child restraint systems approved
for this mass group.
"ISOFIX" and Top Tether child seat mounting system*
Child seats can be secured quickly, easily
and safely on the rear outer seats with the
"ISOFIX" and Top Tether* system.
Two "ISOFIX" retaining rings are fitted on
each rear seat. In some vehicles, the rings
are secured to the seat frame and, in others,
The essentials
a)
Front passenger seat
airbag on airbag off
X U*
X U*
X U*
X U*
X UF*
*: Seats without height adjustment should
be placed in their rearmost position.
Seats with height adjustment should be
placed in their rearmost and highest po-
sition.
they are secured to the rear floor. The "ISO-
FIX" rings are located between the rear seat
backrest and the seat cushioning
The Top Tether* rings are located on the rear
part of the backrests of the rear seats (be-
hind the seat backrest or in the boot)
›››
Fig. 32.
Seating position
Rear side seat
U
U
U
U
UF
The systems include the child restraint sys-
tem mounting with an upper retaining strap
(Top Tether) and lower anchoring points on
the seat.

›››
To understand the compatibility of the "ISO-
FIX" systems in the vehicle, consult the table
›››
Fig. 31. below.
b)
Rear central seat
U
U
U
U
UF
in Safety instructions on page 81
»
19