Placing The Original On The Document Glass - Sharp MX-M266N Operation Manual

PLACING THE ORIGINAL ON THE DOCUMENT GLASS

This section explains how to place the original on the document glass.
Allowed original sizes
Maximum original size
Standard sizes
11" (height) x 17" (width)
A3: 297 mm (height) x 420 mm (width)
Non-standard sizes
11-5/8" (height) x 17" (width)
297 mm (height) x 432 mm (width)
1
2
If you are placing a small non-standard size original on the document glass, it is convenient to place a blank sheet of
8-1/2" x 11" or 5-1/2" x 8-1/2" (A4 or B5) paper on top of the original to facilitate detection of the original size.
3
BEFORE USING THE MACHINE
When the original is a non-standard size, see the
appropriate explanation below for the mode you are
using.
+
2. COPIER "SPECIFYING THE ORIGINAL
(page 2-27)
+
4. FACSIMILE
+
5. SCANNER / INTERNET FAX
SETTINGS" (page 5-53)
Open the automatic document feeder.
Place the original.
Place the original face down in the far left corner of the
document glass.
Document glass scale
mark
5-1/2" x 8-1/2"
(A5)
B5
8-1/2" x 11" (A4)
The original should always be placed in the far left corner,
regardless of its size.
Align the top left corner of the original with the tip of the
Close the automatic document feeder.
After placing the original, be sure to close the automatic
document feeder. If left open, parts outside of the original will
be copied black, causing excessive use of toner.
1-42
"IMAGE SETTINGS" (page 4-45)
"IMAGE
Document glass scale
mark
B5R
8-1/2" x 11"R (A4R)
8-1/2" x 14" (B4)
11" x 17" (A3)
Contents
SIZE"
mark.