Disabling Of Devices; Disabling Of Document Feeder; Disabling Of Finisher; Disabling Of Duplex - Sharp MX-M266N Operation Manual

Disabling of Devices

Use these settings when a peripheral device on the machine has failed or when you wish to temporarily disable a device.

Disabling of Document Feeder

Use this setting to prohibit the use of the automatic
document feeder, such as when the feeder malfunctions.
(When the setting is enabled, scanning is still possible
using the document glass.)

Disabling of Duplex

This is used to disable two-sided printing, such as when
the duplex module malfunctions.

Disabling of Optional Paper Drawer

(When an optional paper tray is installed.)
This setting is used to disable the optional paper drawer,
such as when it malfunctions.

Fusing Control Settings

These are used to control the toner fusing temperature according to the weight of the paper.
These settings apply to plain paper, punched paper, pre-printed paper, letterhead paper, colored paper, and user type
paper.
You can select "16 to 23 lbs." or "23+ to 28 lbs." ("60g/m
• Be sure to use only paper that is in the same weight range as the weight range set here. Do not mix plain or other paper
that is outside the range with the paper in the tray.
• When settings are changed, the changes will take effect after the machine is restarted. To restart the machine see
"TURNING THE POWER ON AND
Disabling of Tray Settings
This setting is used to prohibit tray settings (except for
the bypass tray).

Disabling of Finisher

(When a finisher is installed.)
This setting is used to disable the finisher, such as when
the unit malfunctions.
Disabling of Offset
This setting is used to disable the offset function.

Disabling of Stapler

(When a finisher is installed.)
This setting is used to prohibit stapling, such as when
the stapler unit of the finisher malfunctions.
2 2
to 89g/m
OFF" (page 1-14) in "1. BEFORE USING THE MACHINE ".
7-71
SYSTEM SETTINGS
2 2
" or "90g/m to 105g/m ").
Contents