Hard Disk Drives (Sgi Rackable C2108-Ty10 Chassis); Figure 5-9 Sgi Rackable C2108-Ty10 Disk Drive Locations - Silicon Graphics Rackable C2108-TY10 User Manual

Processor 1
Channel Channel
1 2
1A: 8GB 2A: 8GB
1B: 8GB 2B: 8GB
1C: 8GB 2C: 8GB
1A: 8GB 2A: 8GB
1B: 8GB 2B: 8GB
1C: 8GB 2C: 8GB

Hard Disk Drives (SGI Rackable C2108-TY10 Chassis)

007-5688-003
Table 5-3 Non-Optimal Memory DIMM Configurations (continued)
Channel Channel
3 1
3A: 8GB 1A: 8GB
3B: 8GB 1B: 8GB
3C: none 1C: 8GB
3A: 8GB 1A: 8GB
3B: 8GB 1B: 8GB
3C: 8GB 1C: 8GB
The 2U chassis supports a maximum of eight SAS or SATA disk drives. Install the drives from
left to right. Note: All disk drive bays must be populated to maintain system thermals. Drive bays
must either have a disk drive or a drive blank installed.
Drive 4
Drive 0
Figure 5-9
SGI Rackable C2108-TY10 Disk Drive Locations
The supported disk drive configurations are as follows:
• LSX-CONFIG-JBOD
JBOD, supports any number of drives between one and eight. The operating system is
placed on the disk drive in location 0. All other drives are data drives.
• LSX-CONFIG-RAID0
Disk striping without parity, supports any number of drives between two and eight. Note: all
drives must be the same type. The operating system will be striped across all drives in the
system. This configuration is not recommended.
Hard Disk Drives (SGI Rackable C2108-TY10 Chassis)
Processor 2
Channel Channel
2 3
2A: 8GB 3A: 8GB
2B: 8GB 3B: 8GB
2C: 8GB 3C: none
2A: 8GB 3A: 8GB
2B: 8GB 3B: 8GB
2C: 8GB 3C: 8GB
COMP ACT
Drive 5
Drive 1
Total Node
Memory/
Memory
Core
Size
16 GB/core 128 GB
18 GB/core 144 GB
Drive 6 Drive 7
Drive 2 Drive 3
Maximum
Mem
Speed
(MT/s)
800
800
RESET
45