Static-Sensitive Device; Precautions; Unpacking; Control Panel - Silicon Graphics Rackable C2108-TY10 User Manual

Static-Sensitive Device

Precautions

Unpacking

Control Panel

007-5688-003
Electrostatic discharge (ESD) can damage electronic components. To prevent damage to any
printed circuit boards (PCBs), it is important to handle them very carefully. The following
measures are generally sufficient to protect your equipment from ESD damage.
• Use a grounded wrist strap designed to prevent static discharge.
• Touch a grounded metal object before removing any board from its antistatic bag.
• Handle a board by its edges only; do not touch its components, peripheral chips, memory
modules or gold contacts.
• When handling chips or modules, avoid touching their pins.
• Put the serverboard, add-on cards and peripherals back into their antistatic bags when not in use.
• For grounding purposes, make sure your computer chassis provides excellent conductivity
between the power supply, the case, the mounting fasteners and the serverboard.
The serverboard is shipped in antistatic packaging to avoid static damage. When unpacking the
board, make sure the person handling it is static protected.
The control panel (located on the front of the chassis) must be connected to the JF1 connector on
the serverboard to provide you with system status indications. A ribbon cable has bundled these
wires together to simplify the connection. Connect the cable from JF1 on the serverboard to the
Control Panel PCB (printed circuit board). Make sure the red wire plugs into pin 1 on both
connectors. Pull all excess cabling out of the airflow path. The LEDs inform you of system status.
See Chapter 3 for details on the LEDs and the control panel buttons. Details on JF1 can be found
in Chapter 5.
Static-Sensitive Device
51