Quiet Boot; Addon Rom Display Mode; Bootup Num-Lock; Wait For 'F1' If Error - Silicon Graphics Rackable C2108-TY10 User Manual

Table of Contents

7: BIOS

Quiet Boot

This option allows the bootup screen options to be modified between POST messages or the OEM

logo. Select Disabled to display the POST messages. Select Enabled to display the OEM logo

instead of the normal POST messages. The options are Enabled and Disabled.

This sets the display mode for Option ROM. The options are Force BIOS and Keep Current.

This feature selects the Power-on state for Numlock key. The options are Off and On.

This forces the system to wait until the 'F1' key is pressed if an error occurs. The options are

Disabled and Enabled.

This feature displays "Press DEL to run Setup" during POST. The options are Enabled and

Disabled.

Interrupt 19 is the software interrupt that handles the boot disk function. When this item is set to

Enabled, the ROM BIOS of the host adaptors will "capture" Interrupt 19 at boot and allow the

drives that are attached to these host adaptors to function as bootable disks. If this item is set to

Disabled, the ROM BIOS of the host adaptors will not capture Interrupt 19, and the drives attached

to these adaptors will not function as bootable devices. The options are Enabled and Disabled.

This section describes power configuration options.

007-5688-003

Table of Contents

Do you have a question about the Rackable C2108-TY10 and is the answer not in the manual?