Table of Contents
Advertisement
Putting a call partner on hold
You want to briefly interrupt the active call.
You can put the call party on hold and then take them back again on the
same phone.
Putting the active call party on hold:
Press the Hold key.
➔
The call party is put on hold. The LED on the line key flashes.
Take back the call party on hold:
Press the Hold key or the flashing line key.
➔
The call is active again.
Parking conversation partner
You would like to keep the person you are talking to on hold without block-
ing a phone line.
You may park
again on the same phone on which you parked the person.
You must save this function to a configurable key using Self Service Portal
(see chapter "Configuring or deleting a key assignment", page 88).
Parking the active call party:
Press the function key for
➔
The call party is parked. The LED of the function key is red (Mitel 6865 SIP
only).
Notes:
The display returns to idle. The person you talked to will remain parked until they
put down the handset.
Recommence conversation with the parked call party:
1. Press the function key for Park.
➔
2. Pick up the handset.
➔
1) from MiVoice Office 400 communication server software version R4.0 SP1
onwards
Mitel 6863 SIP / Mitel 6865 SIP
eud-1663/1.2 – R4.0 SP1 – 01.2016
1)
the person you are talking to and then pick up the call
Hand-free mode is activated.
You are connected via the handset.
Park
and put down the handset.
Phoning
37
Advertisement
Table of Contents
