Table of Contents
Advertisement
Installation Instructions - Flush Installation
STEP 9 INSTALL DOOR PANELS
Install door panel:
• Open door to 90°. Remove the 4 Phillips head screws from
the door handle.
• Remove the handle. Retain all screws.
• Remove the 4 screws holding the trim, then lift off the trim.
Retain the screws.
Custom Handles
• Custom handles must be used for flush installation. The
handle must be properly secured to the overlay panel before
sliding the panel into the trim.
• The cabinet manufacturer will supply the custom handle and
hardware.
• Discard the supplied handle.
• Slide the overlay panel into the door trim.
• reinstall trim by securing with all 8 screws retained in
previous steps.
• Follow the same procedures to install the drawer panel.
34
Advertisement
Table of Contents
