Table of Contents
Advertisement
Installation Instructions - Flush Installation
STEP 2A WATER LINE INSTALLATION WITH
A REVERSE OSMOSIS SYSTEM
Skip this step when not using an RO System
If the water supply to the refrigerator is from a Reverse
Osmosis Water System, use the refrigerator's filter bypass
plug. Using the refrigerator's water filtration cartridge with
the RO filter can result in hollow ice cubes.
Filter B pass Plug
STEP 3 INSTALL SIDE PANELS
Skip this step when not using side panels.
If you are using 1/4" side panels, they should be
inserted into the case trim. Fasten the panels to the
refrigerator with stick-on hook and loop fastener strips
before setting refrigerator in place.
STEP 4 INSTALL CASE TRIM
The unit arrives with case trim for standard installation
attached. Flush installation case trim is provided.
Remove the factory installed case trim. Install new case
trim using supplied right hand and left hand case trim
pieces and case trim screws. Attach case trim to each
side of case as shown in illustration using case trim
screws in holes provided down each side of the case.
STEP 5 ANIT-TIP PROCEDURE
WARNING
These refrigerators are top heavy, especially
with any doors open, and must be secured to
prevent tipping forward which could result in
death or serious injury. Read and follow the
entire installation instructions for securing the
refrigerator with the anti-tip system.
AVERTISSEMENT
basculement
Ces réfrigérateurs présentent une partie
supérieure lourde, en particulier avec une porte
ouverte; ils doivent donc être fixés pour prévenir le
basculement vers l'avant et le risque concomitant
de blessure grave ou fatale. Lisez et suivez
les instructions d'installation complètes pour
l'installation du système anti-basculement.
• Cut a 1" x 4" block, 35" long.
• Measure and mark under the soffit,
5-1/4" from the front edge of the
cabinet.
• Secure the wood block to under the
soffit. From the bottom of the block
to the finished floor should measure
84". See the illustration.
• The kit supplied with the unit contains 2 lag bolts and 4 toggles
with bolts. The wall bracket will be attached to the wall in 4
places.
• Measure
the opening
where the
unit is to be
installed.
Mark the
center with a
vertical line.
• Measure up
82" from the
floor. Mark
82"
this point on
the wall.
• Using a
level, draw a
horizontal line
on the wall at
this height.
To Floor
30
Tip Over Hazard.
Risque de
Advertisement
Table of Contents
