Zidi240 Model Only; Custom Handles; Overlay Panels; Backer Panels - Monogram ZIDS240 Installation Instructions Manual

STEP 1 REMOVE PACKAGING

AND INSTALLATION PARTS
• Remove corner blocks and foam drawer stops.
• Remove all packing material, tape and protective
plastic coverings.
WARNING
Small objects are a choke hazard for
children. Remove and discard any parts not used.
WARNING
TIP OVER HAZARD
These appliances are top heavy, especially with any
doors open, and must be secured to prevent tipping
forward which could result in death or serious injury.
Read and follow the entire installation instructions
for securing the appliance with the anti-tip system.
6

Installation Instructions

STEP 2 INSTALL CUSTOM 3/4"
DRAWER PANELS AND
HANDLES
3/4" Overlay Panel Dimensions
Model ZIDI240 requires field-installed
overlay drawer panels.
• The overlay panels must be secured
to 1/4" thick backer panels that slide
into the trims. A .10" thick spacer
panel must be placed between the
overlay and backer panels.
• Custom handles of your choice,
supplied by your cabinet maker,
must be installed on these overlay
panels. Countersink all screws into
the backer panels. Screws cannot protrude from the

backer panels.

IMPORTANT NOTE: Maximum total weight for custom
drawer panels are 25 pounds (12-1/2 pounds maximum
each drawer).
A
3/4" Overlay Panel Dimensions (in inches)
12-1/2 lbs. max.
B
1/4" Backer
*
0.10" Spacer
12-1/2 lbs. max. B
3/4" Overlay
*Maintain a 1/4" min. gap between
top and bottom drawer panels.
Assemble overlay panels with glue and screws.
• Center spacer panel on the
backer panel, left to right and
top to bottom. Secure the panels
with glue.
• Center the spacer/backer
panel on the overlay panel.
Secure with glue and screws.
Countersink all screws into the
backer panel.

(ZIDI240 model only)

Overlay
Panel
Drawer
1/4"
.10 Inch
Backer
Spacer
Panel
A (Width) B (Height)
23-3/16" 14-11/16"
22-1/2" 14-3/16"
23-5/8" 15-1/16"
Overlay Panel
Spacer Panel
Backer Panel
1" = 2.5 cm; 1' = 0.3 m
31-51545-6