Table of Contents
Advertisement
Installation Instructions - Flush Installation
STEP 5 INSTALL ANTI-TIP BRACKET (cont.)
Remove Grilles for Access to Anti-Tip Locking Hooks
Fresh Food Unit
• Open the access door.
• Remove the 4 screws from the grille.
• Pull the bottom of the grille forward, down and out to
remove.
Freezer Unit
• Open the access door.
• Remove the 4 screws from the grille.
• Pull the bottom of the grille forward, down and out to
remove.
STEP 6 ALTERNATE ANTI-TIP PROCEDURE
The refrigerator must be secured to prevent tipping.
If the anti-tip bracket cannot be used, this alternate
method can be used to prevent the unit from tipping.
• Raise the grille panel to access case trim.
• Use a 3/16" bit to drill four evenly spaced clearance
holes through the metal top case trim.
Power Cord
Locate the power cord inside the left cavity. If it has not
been adjusted so the plug is easily accessible, do so now.
Move Unit into Final Position
• Move appliance toward its final installed location. Align
the tabs on the wall bracket with the openings in the back
of the unit.
• The unit has "L" bolts in the upper left and right corners
inside of the access compartment. These bolts will
interlock with the wall bracket and secure the unit using
the washers and hair pin cotters in the hardware kit once
the unit has been leveled and is in the final position.
• Use a 1/16" bit to drill to pilot holes through the metal
clearance holes and into the wood soffit. The holes
should be centered in the soffit or a 3/4" min. wood
brace. The brace spanning the enclosure must be
securely fastened to cabinets on both sides.
• Install four, 1-1/2" drywall screws into the pilot holes.
• If no soffit above the unit, drill screws into adjacent
cabinets through the side case trim.
32
Advertisement
Table of Contents
