Step 3 Install Side Panels; Step 4. Anti-Tip Procedures - Monogram ZIRS360NHLH Installation Instructions Manual

36” built-in all-refrigerators and all-freezers
Hide thumbs Also See for ZIRS360NHLH:
Table of Contents

Advertisement

Installation Instructions - Standard Installation

STEP 3 INSTALL SIDE PANELS

Skip this step when not using side panels
If you are using 1/4" side panels, they should be insert-
ed into the case trim.
STEP 4 INSTALL ANTI-TIP BRACKET
WARNING
The unit is top-heavy and must be secured to prevent the
possibility of tipping forward.
AVERTISSEMENT
basculement
L'appareil ménager est beaucoup plus lourd en haut et il
faut le maintenir en place pour éviter la possibilité de son
basculement vers l'avant.
• The kit supplied with the unit contains 2 lag bolts and 4
toggles with bolts. The wall bracket will be attached to the
wall in 4 places.
• Measure the opening where the unit is to be installed.
Mark the center with a vertical line.
• Measure up 81 1/2" from the floor. Mark this point on the
wall.
• Using a level, draw a horizontal line on the wall at this
height.
• Locate at least 2 studs on the back wall. Mark these
points on the horizontal line.
Tip Over Hazard.
Risque de
Fasten the panels to the unit with stick-on hook and loop
fastener strips before setting unit in place.
• Place the bottom of the wall bracket with tabs on the hor-
izontal line. Align the center notch on the bracket with the
center line on the wall.
Two Additional
Hole Locations at
Ends of Brackets
• The anti-tip wall bracket has a series of holes. Select 2 holes
that match with the located studs. Make sure the holes
selected are on the center of the studs. Mark the wall at
Line on Wall
these points.
• Mark an additional hole at each end of the bracket. If one of
the studs is closer to the end of the bracket, mark an addi-
tional hole towards the center of the bracket.
• Drill 1/2" holes into the wall board at the locations marked
for the toggles to be mounted (not the stud markings).
• Drill 3/16" holes into wooden studs where marked. If steel
stud construction, drill 1/2" holes into the studs where
marked. You will use 2 toggles with the metal studs.
14
Wall Bracket
Center
Line On Wall
Wall Studs
Center
31-49140

Advertisement

Table of Contents
loading

This manual is also suitable for:

Zifs360nhrhZifs360nhh

Table of Contents