Step 5 Install Side Panels; Step 6. Anti-Tip Procedures - Monogram ZISB36 Series Installation Instructions Manual

Table of Contents

Advertisement

Available languages

Available languages

Installation Instructions - Standard Installation
STEP 3 INSTALL WATER LINE (Cont.)
SmartConnect
Refrigerator Tubing Kits are available
in the following lengths:
2' (.6 m)
WX08X10002
8' (2.4 m)
WX08X10006
15' (4.6 m) WX08X10015
25' (7.6 m) WX08X10025
Shut off the main water supply.
Turn on the nearest faucet long enough to clear the
line of water.
• Install a shut-off valve between the icemaker water
valve and cold water pipe in a basement or cabinet.
The shut-off valve should be located where it will be
easily accessible.
• Turn on the main water supply and flush debris.
Run about a quart of water through the tubing into a
bucket. Shut off the water supply at the shut-off valve.
NOTE: Saddle type shut-off valves are included in many
water supply kits. Before purchasing, make sure a saddle
type valve complies with your local plumbing codes.
NOTE: Commonwealth of Massachusetts Plumbing
Codes 248CMR shall be adhered to. Saddle valves
are illegal and use is not permitted in Massachusetts.
Consult with your licensed plumber.
STEP 4 WATER LINE
INSTALLATION WITH A REVERSE
OSMOSIS SYSTEM OR OTHER
HOUSEHOLD FILTRATION SYSTEM
Skip this step when not using an RO System or
other household filtration system.
If the water supply to the refrigerator is from a household
filtration system, use the refrigerator's filter bypass plug.
Using the refrigerator's water filtration cartridge with the
RO filter can result in hollow ice cubes.
Rotate Counterclockwise
to Remove
To obtain a free bypass plug, visit monogram.com or
call 800.444.1845. In Canada, visit monogram.ca or call
800.661.1616. The bypass plug is installed in the same
way as a filter cartridge.
The icemaker will not operate without the filter or filter
bypass plug.
31-1000450 Rev. 1
Filter Bypass
Plug
17

STEP 5 INSTALL SIDE PANELS

Skip this step when not using side panels.
If you are using 1/4" (0.63 cm) side panels, they should
be inserted into the case trim. Fasten the panels to the
refrigerator with stick-on hook and loop fastener strips
before setting the refrigerator in place.
STEP 6 ANTI-TIP PROCEDURE
WARNING
These refrigerators are top heavy, especially with
any doors open, and must be secured to prevent
tipping forward which could result in death or
serious injury. Read and follow the entire installation
instructions for securing the refrigerator with the anti-
tip system.
AVERTISSEMENT
basculement
Ces réfrigérateurs présentent une partie supérieure
lourde, en particulier avec une porte ouverte; ils
doivent donc être fixés pour prévenir le basculement
vers l'avant et le risque concomitant de blessure
grave ou fatale. Lisez et suivez les instructions
d'installation complètes pour l'installation du système
anti-basculement.
Tip Over Hazard.
Risque de

Advertisement

Table of Contents
loading

Table of Contents