Step 7 Adjust Door Swing; Step 8 Install Grille Panel - Monogram ZICS360NHRH Installation Insrtuctions

Installation Instructions - Flush Installation

STEP 7 ADJUST DOOR SWING

NOTE: This refrigerator has a 3-position door stop.
When space does not allow the door to swing open
fully to 115°, you may change the door swing to a 90°
opening. Skip this step if door opening is satisfactory
for your installation situation.
• Lift the grille panel to access the wire cover trim.
• Remove screws on both sides of the wire cover trim
and rotate off.
Remove
Wire Cover
Trim Screws
• Use pliers to unscrew door stop and reinstall into the
90° or 130° (standard only) position.
Pin Location
for 90°
Door Swing
• Reinstall the wire cover trim.
WARNING
Door Trim Pinch Point Hazard
Improper installation can lead to a finger pinch
point hazard between the side door trim and the
cabinets when operating the door, especially
with children. To minimize this risk you must
follow the installation instructions for cabinet
dimensions, trim assembly, and door stop angle.
Pin Location
as Shipped
for 115°
Door Swing
33

STEP 8 INSTALL GRILLE PANEL

• Raise the grille panel to stop position.
• Loose screws on side trim behind frame. Remove
bottom trim.
• Slide panel over the metal backer panel and into
the trim.
• If necessary, tap with a wood block until panel slips
under the top trim piece.
• Reassemble bottom trim. Tighten screws.