Table of Contents
Advertisement
Installation Instructions - Stainless Steel Installation
STEP 2A WATER LINE INSTALLATION WITH
A REVERSE OSMOSIS SYSTEM
Skip this step when not using an RO System
If the water supply to the refrigerator is from a Reverse
Osmosis Water System, use the refrigerator's filter bypass
plug. Using the refrigerator's water filtration cartridge with
the RO filter can result in hollow ice cubes.
Filter B pass Plug
STEP 3 INSTALL SIDE PANELS
Skip this step when not using side panels.
If you are using 1/4" side panels, they should be inserted
into the case trim. Fasten the panels to the refrigerator
with stick-on hook and loop fastener strips before setting
refrigerator in place.
STEP 4 ANIT-TIP PROCEDURE
WARNING
These refrigerators are top heavy, especially
with any doors open, and must be secured to
prevent tipping forward which could result in
death or serious injury. Read and follow the
entire installation instructions for securing the
refrigerator with the anti-tip system.
AVERTISSEMENT
basculement
Ces réfrigérateurs présentent une partie
supérieure lourde, en particulier avec une porte
ouverte; ils doivent donc être fixés pour prévenir le
basculement vers l'avant et le risque concomitant
de blessure grave ou fatale. Lisez et suivez
les instructions d'installation complètes pour
l'installation du système anti-basculement.
• The kit supplied with the unit contains 2 lag bolts and 4
toggles with bolts. The wall bracket will be attached to
the wall in 4 places.
• Measure the opening where the unit is to be installed.
Mark the center with a vertical line.
• Measure up 81 1/2" from the floor. Mark this point on
the wall.
• Using a level, draw a horizontal line on the wall at this
height.
• Locate at least 2 studs on the back wall. Mark these
points on the horizontal line.
42
Tip Over Hazard.
Risque de
Advertisement
Table of Contents
