Or Other Household Filtration System; Step 3 Install Side Panels; Step 4. Anti-Tip Procedures - Monogram 36” Installation Instructions Manual

Built-in bottom-freezer refrigerators
Hide thumbs Also See for 36”:
Table of Contents

Advertisement

Available languages

Available languages

Installation Instructions - Standard Installation
STEP 2A WATER LINE
INSTALLATION WITH A REVERSE
OSMOSIS SYSTEM OR OTHER
HOUSEHOLD FILTRATION SYSTEM
Skip this step when not using an RO System or
other household filtration system
If the water supply to the refrigerator is from a
household filtration system, use the refrigerator's filter
bypass plug. Using the refrigerator's water filtration
cartridge with the RO filter can result in hollow ice
cubes.
Filter Bypass Plug

STEP 3 INSTALL SIDE PANELS

Skip this step when not using side panels.
If you are using 1/4" (0.63 cm) side panels, they should
be inserted into the case trim. Fasten the panels to the
refrigerator with stick-on hook and loop fastener strips
before setting refrigerator in place.
31-1000452 Rev. 1
STEP 4 ANTI-TIP PROCEDURE
WARNING
These refrigerators are top heavy, especially with
any doors open, and must be secured to prevent
tipping forward which could result in death or
serious injury. Read and follow the entire installation
instructions for securing the refrigerator with the
anti-tip system.
AVERTISSEMENT
basculement Ces réfrigérateurs présentent une partie
supérieure lourde, en particulier avec une porte ouverte;
ils doivent donc être fixés pour prévenirle basculement
vers l'avant et le risque concomitant de blessure grave
ou fatale. Lisez et suivez les instructions d'installation
complètes pour l'installation du système anti-basculement.
ADVERTENCIA
Estos refrigeradores son inestables, especialmente
cuando una puerta se encuentre abierta, y deberán estar
asegurados a fin de evitar caídas hacia adelante que
podrían resultar en la muerte o en lesiones graves. Lea y
siga las instrucciones de instalación en su totalidad para
asegurar el refrigerador con el sistema anti volcaduras.
• The kit supplied with the unit contains 2 lag bolts and
4 toggles with bolts. The wall bracket will be attached
to the wall in 4 places.
• Measure the opening where the unit is to be installed.
Mark the center with a vertical line.
15
Tip Over Hazard.
Risque de
Riesgo de Caídas

Advertisement

Table of Contents
loading

Table of Contents