Step 5. Level Refrigerator; Step 7 Alternate Anti-Tip Procedure; Step 8 Adjust Door Swing - Monogram ZICS360NHRH Installation Insrtuctions

Installation Instructions - Stainless Steel Installation
STEP 7 ALTERNATE ANTI-TIP
PROCEDURE
The refrigerator must be secured to prevent
tipping. When the anti-tip bracket cannot be used,
this alternate method can be used to prevent the
refrigerator from tipping.
• Raise the grille panel to access case trim.
• Use a 3/16" bit to drill four evenly spaced clearance
holes through the metal top case trim.
• Use a 1/16" bit to drill to pilot holes through the metal
clearance holes and into the wood soffit. The holes
should be centered in the soffit or a 3/4" min. wood
brace. The brace spanning the enclosure must be
securely fastened to cabinets on both sides.
• Install four, 1-1/2" drywall screws into the pilot holes.
• If no soffit above the unit, drill screws into adjacent
cabinets through the side case trim.

STEP 8 ADJUST DOOR SWING

NOTE: This refrigerator has a 3-position door stop.
When space does not allow the door to swing open
fully to 115°, you may change the door swing to a 90°
opening. A 130° door swing is available for standard
installation only. If used for flush installation, damage
will occur to wood panels. Skip this step if door
opening is satisfactory for your installation situation.
• Lift the grille panel to access the wire cover trim.
• Remove screws on both sides of the wire cover trim
and rotate off.
• Use pliers to unscrew door stop and reinstall into the
90° or 130° (standard only) position.
Pin Location
for 90°
Door Swing
• Reinstall the wire cover trim.
45
Remove
Wire Cover
Trim Screws
Pin Location for
130° Door Swing
(Standard Only)
Pin Location
as Shipped
for 115°
Door Swing