Replacing The Status-Light Board; Procedure; Post-Requisites - Dell Alienware 17 Service Manual

Replacing the status-light board

WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in
Before working inside your
follow the instructions in
safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Topics:
•

Procedure

•

Post-requisites

Procedure
1 Align the screw holes on the status-light board with the screw holes on the
palm-rest assembly.
2 Replace the screws that secure the status-light board to the palm-rest
assembly.
3 Slide the status-light board cable into the connector on the status-light board
and press down the latch to secure the cable.
Post-requisites
1 Follow the procedure from step 5 to step 11 in "Replacing the
2 Replace the base
computer. After working inside your computer,
After working inside your
panel.
computer. For more
Replacing the status-light board
16
palm rest".
44