Replacing the status-light board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
working inside your
the instructions in
practices, see the Regulatory Compliance home page at
regulatory_compliance.
Procedure
1
Align the screw holes on the status-light board with the screw holes on the
computer base.
2
Replace the two screws (M2x3) that secure the status-light board to the
computer base.
3
Slide the status-light board cable into the connector on the status-light board
and close the latch to secure the cable.
Post-requisites
1
Follow the procedure from step 3 to step 9 in
keyboard
assembly".
2
Replace the
rear
3
Replace the battery.
4
Replace the
base
computer. After working inside your computer, follow
After working inside your
cover.
cover.
computer. For more safety best
www.dell.com/
"Replacing the palm rest and
Before
63