Table of Contents
Advertisement
Replacing the status-light
board
WARNING: Before working inside your computer, read the
safety information that shipped with your computer and
follow the steps in
After working inside your computer, follow the instructions
in
After working inside your
practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Procedure
1
Align the screw holes on the status-light board with the screw holes on the
palm-rest assembly.
2
Replace the screws that secure the status-light board to the palm-rest
assembly.
3
Slide the status-light board cable into the connector on the status-light
board and press down the latch to secure the cable.
Post-requisites
1
Follow the procedure from step 5 to step 11 in "Replacing the
2
Replace the
base
42
Before working inside your
panel.
computer. For more safety best
computer.
palm
rest".
Advertisement
Table of Contents
