Ram Replacement - HP 9000 A-180 User Manual

1. Each RAM board has its size marked on one side of the board near an upper
2. The white stripe on the end of the board identifies the end of the board that must
3. The notch at the lower corner of the board also indicates the end of the board
CAUTION
Always handle RAM boards by their edges. Failure to comply with this precaution
may result in damage to the RAM.
Step 1. Open the ejector levers (down position) on each side of the RAM.
Step 2. Grasp the RAM by the edges and lift straight up.
Step 3. Set it carefully on the grounding mat.

RAM Replacement

CAUTION
Keep RAM boards in their protective anti-static bags until you are ready to install
them. Always handle RAM boards by their edges after you have removed them from
their protective anti-static bags. Be sure that an anti-static wrist strap is still attached
to your wrist and grounded to the cabinet main chassis when you handle and install
Chapter 3
A-Class Server RAM Removal and Replacement
corner: 16MB, 32MB, 64MB, 128MB, or 256MB. (In the illustration shown, the
marking is on the reverse side of the board.)
be toward the white ejector lever.
that must go toward the white ejector lever.
A-Class System Service
97