A-Class System Service
A-Class Server Disk Drive Removal and Replacement
Step 3. To Re-install the disk drive(s) follow the removal instructions in reverse.
a. re-cable the disk drive(s),
CAUTION
Ensure that cables are connected correctly:
Failure to observe these precautions may result in bent or broken pins.
b. remount the disk drive(s) in the bracket, and
c. reinstall the bracket in the server.
NOTE
Lift either side of the disk bracket to ensure that the tabs on the bracket are seated
properly in the slots provided.
110
Set the upper drive to ID to 5
Set the lower drive to ID to 6
Match the ribbon cable connector key with the slot on the receptacle.
Match the rounded corners of the power cable connector with the rounded
corners of the receptacle.
Chapter 3