HP 9000 A-180 User Manual page 26

A-Class Server Installation
Stand-Alone A-Class Server Unpack and Install Instructions
Open the Installation Instructions and Regulatory Information
Packet
The Installation Instructions/Regulatory Information Packet contains the following
information:
• Installation Instruction Sheet (A5182-96002), which includes:
Basic cable connection information necessary to power on and boot the
server to the Firmware Main Menu screen.
The Universal Resource Locator (URL) for the A-Class Server home page
on the World Wide Web.
• Regulatory Information. Contains consumer safety and regulatory statements for
the United States and for those countries that require publishing and
dissemination of their own consumer safety and regulatory data.
Installing a Stand-alone System
A-Class servers are compact in design and can be installed on table or desk tops in
the same manner as any standard Personal Computer (PC).
Heating and cooling conditions must be met for the system to function at peak
efficiency.
Attention must be paid to system access. There must be room for external
connections on the rear of the server and there must be ready access to an electrical
outlet with the correct electrical output. These environmental requirements are
found in the section titled, "A-Class Server Site Preparation".
When you have installed the server and are ready to connect external devices, refer
to the,"External Connections" section.
To power up and boot the server, refer to the section titled, "A-Class Server Power
Up and Boot Procedures".
26 Chapter 2