Table of Contents
Advertisement
Step 7. To add "btlan3" driver support to the kernel, edit the /stand/system file and add the
line: btlan3. To access the file, type the following command when the system
prompt "#" displays: vi /stand/system. When the file opens, add the "btlan3"
line.
Step 8. Now, rebuild the kernel and reboot the system. Type the following command when
the system prompt "#" displays: mk_kernel -o /stand/vmunix Press
NOTE
Disregard the /usr/ccs/bin/ld: (Warning) "Linker features were used..." This warning
does not apply to this procedure.
Then, type the following command when the system prompt "#" displays: reboot
-r Press
Step 9. Finally, type the following command when the system prompt "#" displays:
/sbin/set_parms initial Press
complete.
Boot Procedures
Boot to Initial System Loader (ISL) (Optional)
If you wish to verify that all external devices are identified by the server before
booting HP-UX:
Step 1. Interrupt the boot process if AUTOBOOT is enabled.
Step 2. At the firmware Main Menu screen, type, bo pri.
Step 3. At the, Interact with IPL? prompt, type, y.
The ISL> prompt will be displayed.
Run Online Diagnostic Environment (ODE) Mapper (Optional)
Step 1. At the, ISL> prompt, type, ODE.
Step 2. At the, ODE> prompt, type, run mapper.
Compare the ODE Mapper output to the devices present. Address any discrepancies
before continuing. To exit ODE, type exit at the, ODE> prompt. This will return
you to the, ISL> prompt.
Chapter 2
A-Class Server Power Up and Boot Procedures
. The system should now boot with an error-free /etc/rc.log file.
Enter
A-Class Server Installation
. Network configuration is now
Enter
.
Enter
63
Advertisement
Table of Contents
