HP 9000 A-180 User Manual page 60

A-Class Server Installation
A-Class Server Power Up and Boot Procedures
The terminal will display:
At the C:\> prompt, type: arp -d 192.0.0.192 and press
At the C:\> prompt, type: arp -s 192.0.0.192 00-10-83-a6-0a-1e and
press Enter .
At the C:\> prompt, type: ping 192.0.0.192 and press
The terminal will display: Pinging 192.0.0.192 with 32 bytes of
data:
Reply from 192.0.0.192: bytes=32 time=10ms TTL=255
Reply from 192.0.0.192: bytes=32 time=10ms TTL=255
Reply from 192.0.0.192: bytes=32 time=10ms TTL=255
Reply from 192.0.0.192: bytes=32 time=10ms TTL=255
Return to "Configure the Web Browser" and "Configure The integrated A-Class
Web Console Software".
Operating System Software Installation
HP-UX may be installed from removable media (DDS or CDROM) or via a LAN
(Ignite-UX). A-Class servers require a server firmware version of 39.32 or later to
use Ignite-UX. A-Class server firmware is Customer installable and is available as a
firmware patch from the Hewlett Packard Information Technology Resource Center
(HPITRC). "Power Up the Server". Refer to patch installation instructions to install
this firmware patch on A-Class servers. Refer to the web-based documentation
"Power Up the Server" for information on how to configure and use Ignite-UX.
This is a temporary solution for rebuilding an A-Class system from removable
media (diskette or CD) only. This procedure is required because the 10.20 Core
Install media does not include the "btlan3" drivers that you will need for networking
support. This solution is for the HP-UX 10.20 operating system with an Independent
Peripheral Release (IPR) of October 198 (9810) only. It is not needed for HP-UX
11.0 IPR 9810.
60
Internet Physical Address
Address
15.43.248.1 00-00-0c-07-ac-00
192.0.0.192 00-60-b0-a6-0a-1e
Type
dynamic
static
.
Enter
.
Enter
Chapter 2