Table of Contents
Advertisement
A-Class Server Installation
A-Class Server System Installation
A-Class Server System Installation
Overview
The sections listed below describe the procedures you will use to prepare for, install,
and begin operation of, your A-Class server:
"A-Class Server Site Preparation". Contains environmental requirements for
preparing the area where your server is to be located.
"Stand-Alone A-Class Server Unpack and Install Instructions". Details what you
will find when you open the carton containing your A-Class server and how to
set it up for stand-alone operation.
"Cabinet-Mounted A-Class Server System Unpack and Install". Tells you how
to install and connect the server to external devices and power, either as a
stand-alone unit or in an HP-supported cabinet. Unpacking, set up, and
connection information is also included for those who ordered a cabinet from the
factory with one or more servers installed,
"A-Class Server System Software Configuration". Tells you how to install
memory (RAM), cache memory, embedded disk and I/O card add-on
components.
"A-Class Server Power Up and Boot Procedures". Leads you through the
process for powering up external devices and the server, gives the software
commands for customizing the A-Class Secure Web Console IP address, and
lists the steps required for booting the server to an operating state.
"A-Class Server System Software Configuration". Directs you to the software
commands necessary for preparing both the A-Class server and the A-Class
Secure Web Server for operation.
18
Chapter 2
Advertisement
Table of Contents
