HP 9000 A-180 User Manual page 34

A-Class Server Installation
Cabinet-Mounted A-Class Server System Unpack and Install
sufficient slack is available for later maintenance.
Step 4. Connect the cabinet power cord to the appropriate wall outlet.
NOTE
If the cabinet being installed contains a PowerTrust Uninterruptible Power Supply
(UPS), perform the steps shown under the "PowerTrust UPS Option" subsection.
Step 5. Be sure all peripherals outside the cabinet are connected to wall outlets.
The cabinet/server system assembly is now ready for the power up process. Refer to
the section titled, "A-Class Server Power Up and Boot Procedures".
PowerTrust UPS Option
Unpack the PowerTrust UPS and read all the installation information in the
PowerTrust System Guide, part number 5961-8383. Once all the procedures listed in
the UPS guide are complete, perform the following steps to complete the UPS
installation with the cabinet.
1. Position the UPS next to the cabinet on the floor.
2. Remove the jumper cord from the SPU to the PDU inside the cabinet.
3. Install one of the convenience cords (output cord) that came with the UPS into
4. Place the other end of that cord into one of the Output outlets in the back of the
5. The other convenience cord is connected between the UPS and the system
6. Locate the appropriate input line cord for the UPS in the supplemental package
7. Plug the UPS into the appropriate wall outlet.
8. The system should now be ready for power up. Refer to the section titled,
Repackaging the Cabinet for Shipment
Use the original packing material to repackage the cabinet for shipment. If the
packing material is not available, contact your local Hewlett-Packard Sales and
34
the AC receptacle in the back of the SPU.
UPS.
console.
shipped with the UPS.
"A-Class Server Power Up and Boot Procedures".
Chapter 2