Fuel Filter (Wg1605-G-E3, Wg1605-Gl-E3); Electronic Throttle Body (Etb) - Kubota WG1605-G-E3 Workshop Manual

WG1605-G-E3,WG1605-L-E3,WG1605-GL-E3, WSM

[2] FUEL FILTER (WG1605-G-E3, WG1605-GL-E3)

[3] ELECTRONIC THROTTLE BODY (ETB)

The fuel filter is installed in the fuel line between the
fuel tank and the feed pump.
As the fuel flows from the inlet "A" through the filter
element (1), the dirt and impurities in the fuel are filtered,
allowing only clean fuel to penetrate the inside of the
filter element. The cleaned fuel flows out from the outlet
"B".
Type of filter element
Material of filter element
Filter mesh
(1) Filter Element
The ETB is connected to the intake manifold of the
engine. The ETB utilizes an electric motor connected to
the throttle shaft. In addition, an accelerator position
sensor (a foot pedal position sensor) is located in the
operator's compartment. When the engine is running,
electrical signals are sent from the accelerator position
sensor (the foot pedal position sensor) to the Engine
Control Unit (ECU) when the operator depresses or
releases the accelerator. The ECU then sends an
electrical signal to the motor on the ETB to increase or
decrease the angle of the throttle blade, thus increasing
or decreasing the air flow to the engine.
1-M13
ENGINE
Accordion-pleated paper type
Cotton fiber
15 µm (0.00059 in.)
A: Inlet
B: Outlet
9Y1210318ENM0040US0
9Y1210661ENM0017US0
KiSC issued 01, 2012 A