Timing Gear And Camshaft - Kubota WG1605-G-E3 Workshop Manual

WG1605-G-E3,WG1605-L-E3,WG1605-GL-E3, WSM

(2) Timing Gear and Camshaft

Timing Gear Backlash
1. Set a dial indicator (lever type) with its tip on the gear tooth.
2. Move the gear to measure the backlash, holding its mating gear.
3. If the backlash exceeds the allowable limit, check the oil
clearance of the shafts and the gear.
4. If the oil clearance is proper, replace the gear.
Factory specification
Backlash between idle
gear 1 and crank gear
Allowable limit
Factory specification
Backlash between idle
gear 1 and cam gear
Allowable limit
Factory specification
Backlash between idle
gear 1 and injection
pump gear
Allowable limit
Factory specification
(equipped with idle gear
2) Backlash between idle
gear 1 and idle gear 2
Allowable limit
Governor Gear Backlash
Factory specification
Backlash between
injection pump gear and
governor gear
Allowable limit
Factory specification
(equipped with idle gear
2) idle gear 2 and
governor gear
Allowable limit
Idle Gear 1 and 2 Side Clearance
1. Set a dial indicator with its tip on the idle gear.
2. Measure the side clearance by moving the idle gear to the front
and rear.
3. If the measurement exceeds the allowable limit, replace the idle
gear collar.
Factory specification
Idle gear 1 and 2 side
clearance
Allowable limit
1-S46
ENGINE
0.0320 to 0.115 mm
0.00126 to 0.00452 in
0.15 mm
0.0059 in.
0.0360 to 0.114 mm
0.00142 to 0.00448 in
0.15 mm
0.0059 in.
0.0340 to 0.116 mm
0.00134 to 0.00456 in
0.15 mm
0.0059 in.
0.0330 to 0.117 mm
0.00130 to 0.00460 in.
0.15 mm
0.0059 in.
9Y1210661ENS0045US0
0.0300 to 0.117 mm
0.00119 to 0.00460 in.
0.15 mm
0.0059 in.
0.0300 to 0.117 mm
0.00119 to 0.00460 in.
0.15 mm
0.0059 in.
9Y1210661ENS0105US0
0.20 to 0.51 mm
0.0079 to 0.020 in.
0.80 mm
0.031 in.
9Y1210661ENS0046US0
KiSC issued 01, 2012 A