Kubota WG1605-G-E3 Workshop Manual page 115

WG1605-G-E3,WG1605-L-E3,WG1605-GL-E3, WSM
Main Bearing Case Assembly
1. Remove the two main bearing case screws 1 (5), and remove
the main bearing case assembly 1 (1), being careful with
crankshaft bearing 3 (7).
2. Remove the main bearing case assembly 2 (2), the main
bearing case assembly 3 (3) and the main bearing case
assembly (4) as above. Keep in mind, however, that the thrust
bearing (8) is installed in the main bearing case assembly (4).
(When reassembling)
• Clean the oil passage in the main bearing cases.
• Apply clean engine oil to the bearings.
• Install the main bearing case assemblies in original positions.
Since diameters of main bearing cases vary, install them in
order of marking (b) from the gear case side. (Refer to the
figure.)
• Be careful not to confuse the top and bottom of the crankshaft
bearing 3 (7). (Install the bearing with the oil groove (c) up.).
• Match the alignment numbers (a) on the main bearing case
assembly 1.
• Do the same for the main bearing case assembly 2 (2), the main
bearing case assembly 3 (3) and the main bearing case
assembly (4) too.
• When installing the main bearing case 1, 2 and 3, face the mark
"FLYWHEEL" to the flywheel.
• Install the thrust bearing (8) with its oil groove facing outward.
• Confirm that the main bearing case moves smoothly after
tightening the main bearing case screw 1 (5) to the specified
torque.
Tightening torque Main bearing case screw 1
(1) Main Bearing Case Assembly 1
(2) Main Bearing Case Assembly 2
(3) Main Bearing Case Assembly 3
(4) Main Bearing Case Assembly
(5) Main Bearing Case Screw 1
(6) Crankshaft Bearing 2
(7) Crankshaft Bearing 3
(8) Thrust Bearing
1-S37
ENGINE
29.4 to 34.3 N·m
3.00 to 3.49 kgf·m
21.7 to 25.2 lbf·ft
(a) Alignment Number
(b) Marking (A, B, C)
(c) Oil Groove
9Y1210661ENS0034US0
KiSC issued 01, 2012 A