Kubota WG1605-G-E3 Workshop Manual page 123

WG1605-G-E3,WG1605-L-E3,WG1605-GL-E3, WSM
Push Rod Alignment
1. Place the push rod on V blocks.
2. Measure the push rod alignment.
3. If the measurement exceeds the allowable limit, replace the
push rod.
Push rod alignment Allowable limit
Oil Clearance between Tappet and Tappet Guide Bore
1. Measure the tappet O.D. with an outside micrometer.
2. Measure the I.D. of the tappet guide bore with a cylinder gauge,
and calculate the oil clearance.
3. If the oil clearance exceeds the allowable limit or the tappet is
damaged, replace the tappet.
Factory specification
Oil clearance between
tappet and tappet guide
bore
Allowable limit
Tappet O.D. Factory specification
Tappet guide bore I.D. Factory specification
1-S45
ENGINE
0.25 mm
0.0098 in.
9Y1210318ENS0098US0
0.020 to 0.062 mm
0.00079 to 0.0024 in
0.07 mm
0.003 in.
19.959 to 19.980 mm
0.78579 to 0.78661 in
20.000 to 20.021 mm
0.78741 to 0.78822 in
9Y1210661ENS0070US0
KiSC issued 01, 2012 A