Kubota WG1605-G-E3 Workshop Manual page 45

WG1605-G-E3,WG1605-L-E3,WG1605-GL-E3, WSM
Bushing Replacing Tool
Application
• Use to press out and press fit the bushing.
[For small end bushing]
A 157 mm (6.18 in.)
B 24 mm (0.94 in.)
C 120 mm (4.72 in.)
D 21.8 to 21.9 mm dia. (0.859 to 0.862 in. dia.)
E 24.8 to 24.9 mm dia. (0.977 to 0.980 in. dia.)
F 20 mm dia. (0.79 in. dia.)
a 6.3 µm (250 µin.)
b 6.3 µm (250 µin.)
C1 Chamfer 1.0 mm (0.039 in.)
C2 Chamfer 2.0 mm (0.079 in.)
[For idle gear bushing]
A 196 mm (7.72 in.)
B 26 mm (1.0 in.)
C 150 mm (5.91 in.)
D 25.80 to 25.90 mm dia. (1.016 to 1.019 in. dia.)
E 28.80 to 28.90 mm dia. (1.134 to 1.137 in. dia.)
F 20 mm dia. (0.79 in. dia.)
a 6.3 µm (250 µin.)
b 6.3 µm (250 µin.)
C1 Chamfer 1.0 mm (0.039 in.)
C2 Chamfer 2.0 mm (0.079 in.)
Flywheel Stopper
Application
• Use to loosen and tighten the flywheel screw.
A 20 mm (0.79 in.)
B 15 mm (0.59 in.)
C 10 mm dia. (0.39 in. dia.)
D 30 mm (1.2 in.)
E 8.0 mm (0.31 in.)
F 200 mm (7.87 in.)
G-25
GENERAL
9Y1210661GEG0032US0
9Y1210661GEG0036US0
KiSC issued 01, 2012 A