Check And Maintenance; Daily Check Points - Kubota WG1605-G-E3 Workshop Manual

WG1605-G-E3,WG1605-L-E3,WG1605-GL-E3, WSM

4. CHECK AND MAINTENANCE

[1] DAILY CHECK POINTS

Checking Engine Oil Level
1. Level the engine.
2. To check the oil level, draw out the dipstick (1), wipe it clean,
reinsert it, and draw it out again.
Check to see that the oil level lies between the two notches.
3. If the level is too low, add new oil to the specified level.
IMPORTANT
• When using an oil of different maker or viscosity from the
previous one, drain old oil. Never mix two different types of
oil.
• Use the proper SAE Engine oil according to ambient
temperatures.
NOTE
• Be sure to inspect the engine, locating it on a horizontal
place. If placed on gradients, accurately, oil quantity may
not be measured.
• Be sure to keep the oil level between upper and lower limits
of the dipstick. Too much oil may cause a drop in output or
excessive blow-by gas. On the closed breather type engine
in which mist is sucked through port, too much oil may
caused oil hammer. While too little oil, may seize the
engine's rotating and sliding parts.
(1) Dipstick
G-7
GENERAL
9Y1210661GEG0009US0
KiSC issued 01, 2012 A