Kubota WG1605-G-E3 Workshop Manual page 33

WG1605-G-E3,WG1605-L-E3,WG1605-GL-E3, WSM
Fan Belt Tension
1. Measure the deflection (A), depressing the belt halfway
between the fan drive pulley and alternator pulley at specified
force 98 N (10 kgf, 22 lbf).
2. If the measurement is not within the factory specifications,
loosen the alternator mounting screws and relocate the
alternator to adjust.
Deflection (A) Factory specification
(A) Deflection
Fan Belt Damage and Wear
1. Check the fan belt for damage.
2. If the fan belt is damaged, replace it.
3. Check if the fan belt is worn and sunk in the pulley groove.
4. If the fan belt is nearly worn out and deeply sunk in the pulley
groove, replace it.
(A) Good
Checking Battery Electrolyte Level
1. Check the battery electrolyte level.
2. If the level is below than lower level line, add the distilled water
to pour level of each cell.
CAUTION
• Never remove the vent plugs while the engine is running.
• Keep electrolyte away from eyes, hands and clothes.
If you are spattered with it, wash it away completely with
water immediately and get medical attention.
• Wear eye protection and rubber gloves when working
around battery.
G-13
GENERAL
7.0 to 9.0 mm
0.28 to 0.35 in.
9Y1210318GEG0001US0
(B) Bad
9Y1210318GEG0002US0
9Y1210318GEG0026US0
KiSC issued 01, 2012 A