Fuel Filter (Wg1605-G-E3, Wg1605-Gl-E3, Wg1605-Gln-E3); Electronic Throttle Body (Etb) - Kubota WG1605-G-E3 Workshop Manual

WG1605-G-E3,WG1605-L-E3,WG1605-GL-E3, WSM

[2] FUEL FILTER (WG1605-G-E3, WG1605-GL-E3, WG1605-GLN-E3)

[3] ELECTRONIC THROTTLE BODY (ETB)

The fuel filter is installed in the fuel line between the
fuel tank and the feed pump.
As the fuel flows from the inlet "A" through the filter
element (1), the dirt and impurities in the fuel are filtered,
allowing only clean fuel to penetrate the inside of the
filter element. The cleaned fuel flows out from the outlet
"B".
Type of filter element
Material of filter element
Filter mesh
(1) Filter Element
The ETB is connected to the intake manifold of the
engine. The ETB uses an electric motor connected to the
throttle shaft. In addition, an accelerator position sensor
(a foot pedal position sensor) is located in the operator's
compartment. When the engine is running, electrical
signals are sent from the accelerator position sensor (the
foot pedal position sensor) to the Engine Control Unit
(ECU) when the operator depresses or releases the
accelerator. The ECU then sends an electrical signal to
the motor on the ETB to increase or decrease the angle
of the throttle blade, thus increasing or decreasing the air
flow to the engine.
1-M13
ENGINE
Accordion-pleated paper type
Cotton fiber
15 µm (0.00059 in.)
A: Inlet
B: Outlet
9Y1210318ENM0040US0
9Y1210661ENM0017US0
KiSC issued 05, 2014 A