Table of Contents
Advertisement
DLP Projector — Owner's Manual
Image Problems
Problem: No image appears on the screen
1.
Verify the settings on your notebook or desktop PC.
2.
Turn off all equipment and power on again in the correct order.
Problem: The image is blurred
1.
Press the Focus button to adjust the focus on the projector.
2.
Press the Auto button on the remote control to automatically optimize image.
3.
Ensure the projector-to-screen distance is within the specified range.
4.
Check that the projector lens is clean.
Problem: The image is wider at the top or bottom (trapezoid effect)
1.
Position the projector so it is as perpendicular to the screen as possible.
2.
Press the Keystone H or Keystone V button on the remote control to correct the problem.
Problem: The image is reversed
Check the Rear Projection on the Setup menu of the OSD.
Problem: The image is streaked
1.
Set the Phase and Frequency settings on the Picture menu of the OSD to the default settings.
2.
Ensure the problem is not caused by a connected PC's video card, connect to another computer.
Problem: The image is flat with no contrast
Adjust the Contrast setting on the Picture menu of the OSD.
Problem: The color of the projected image does not match the source image
Adjust the Color Temperature and Gamma settings on the Picture > Advanced menu of the OSD.
Laser Diode Problems
Problem: There is no light from the projector
1.
Check that the power cable is securely connected.
2.
Ensure the power source is good by testing with another electrical device.
3.
Restart the projector in the correct order and check that the Light LED is in green.
60
—
—
Advertisement
Table of Contents
