Helpful Hints-Problems And Solutions - Eiki LC-120 Owner's Instruction Manual

HELPFUL HINTS-Problems and Solutions
Check the following chart before requesting service.
PROJECTOR
Problem:
Try these Solutions:
No power.
Ф Plug the projector into an AC outlet
Ө Press the MAINS switch to ON.
© Press the POWER (LAMP) ON/OFF button to ON.
No sound from builtin speaker.
Ф Press the VOLUME (А) and (W) to (A).
Ф Check audio cable connection from audio input source.
© Check SP OUT switch to "INT." position.
Picture is reversed.
Ф Press the PICTURE SCAN switch.
Picture blurred or color faded.
© Check the projection distance 0.7m ~ 3.3m.
© Adjust the FOCUS control.
NOTE: Moving the projector from a cool temperature location to a
warm temperature location may result
condensation on the lens. in such an event, leave the
projector OFF and wait until condensation disappears.
im moisture
BUILT-IN VCP
Problem:
Try these Solutions:
No power.
© Plug the projector into an AC outlet.
© Press the MAINS switch to ON.
© Press the VCP POWER button to ON.
Playback picture does not appear.
format.
© The colour system switch setting does not correspond to the tape
Playback picture is black and
White or no sound is reproduced.
Ф 1: the colour system on projector correctly selected?
Interference in playback picture.
Ф Adjust the tracking control.
© Dust or dirt on video heads.
Take the unit to an Authorized Service Station or dealer.
CONCERNING CONDENSATION
BE CAREFUL OF CONDENSATION
Condensation is the moisture that forms on the outside
of a glass when you fil it with cold water. Condensation
сап also form inside a VCP when it is suddenly moved
from а cold place to a warm, humid one, or when а
heater has been turned on to quickly heat the room.
Particular care must be taken with set because water
particles that form on the video head drum, which is the
video unit mechanism, can cause the video tape to stick
to the drum. This prevents proper tape travel and may
damage both tape and mechanism.
Follow the procedures below the first time you use
the set, and whenever you use it in places which are
subject to condensation:
1. Plug the power cord into a AC outlet
2. Tum on the VCP power to warm it up and speed up
the drying of any water particles that may have
formed on the video head drum.
3. Do not insert a video cassette
R takes about 1-1/2 to 2 hours to completely
eliminate condensation. Walt at least this long
before using the set.
ES