Manual And Auto-Select Mode - Bentel Security KYO 320 Installation Manual

Software Outputs 7, 8, 9 and 10 (available for this ap-
plication) must be: Monostable and Normally open
(DO NOT program these Outputs as Reserved).
The ON Time of the Output determines how long the
"Voice Module" will stay ON after activation, therefore,
must be long enough to allow the User to Listen-in on
the location. Each Output, connected as shown in the
wiring diagram (Figure 4) will be able to control one
"Voice Module".
Use the Partition and/or Control panel Events in the
Event-Actions page to activate the Dialler and Telepho-
ne Communicator Outputs. In this way, the zone events
will be available for "Voice Module" management. Pro-
gram the zone events (relevant to the location concer-
ned) to activate the Output that controls the respective
"Voice Module". Repeat this procedure for the other
Outputs, as required.
Upgrade FirmwareAuto-select mode will allow the User
(during a dialler call) to activate Remote listen-in on the
location that generated the Alarm.
*
Connect ONLY the [+] terminals of the
VOX-REM board to the terminal [+12] of
the Voice Board.
OC1 OC2
Omnia/4R
RL1 RL2
SP- SP+ MIC
st
1 Voice module
Figure 4 Wiring for Manual-select Listen-in mode
KYO320
OC3 OC4 +12
RL3 RL2
*
SP- SP+ MIC
nd
2 Voice module
n Manual and Auto-select mode
Manual and Auto-select Listen-in can be integrated.
This will allow the User to select (manually) specific lo-
cations during standby status.
Use 4 Outputs for Manual-select Listen-in mode, and 4
Outputs for Auto-select listen-in mode.
The Outputs must be connected in two's — one Manual
and one Auto, as shown in Figure 4.
To ensure proper functioning of Auto-select mode, the
manually controlled Outputs must be in standby status.
Therefore, the Outputs must always be restored to
Standby when a manually controlled listen-in session
ends.
M-IN/OUT Exp.01
programmed
as Output
T1 T2 T3 T4 +F
Voice board
SPK- SPK+ MIC +12
*
SP- SP+ MIC
rd
3 Voice module
APPENDIX
M-IN/OUT Exp.02
programmed
as Input
T1 T2 T3 T4
OC1 OC2 OC3 OC4 +12
Omnia/4R
RL1 RL2 RL3 RL2
* *
SP- SP+ MIC
th
4 Voice module
41