Keys/Card - Bentel Security KYO 320 Installation Manual

Armed Mess.n ---
None
15. Using A or B , select the Voice message (or None),
assigned to Partition Armed status, then press ENTER:
Disar.mess n.---
None
16. Using A or B, select the Voice message (or None),
assigned to Partition Disarmed status, then press
ENTER:
Partition Code
Code 000000
17.Enter the Partition code, then press ENTER to go
back to step 3.
If the Send always option is disabled (refer to "Digital
Communicator" section), the Digital Communicator
will send the Partition code and the Event Code to the
Central Station/s when a partition related event occurs
(associated with the Digital Communicator).
+
The Partition Code must have 6 digits.

Keys/Card

From the "PROGRAMMING" menu.
PROGRAMMING
Configuration
1. Using A or B, select the Keys option.
PROGRAMMING
Keys /Card
2. Press ENTER:
Keys /Card
Digital Key
3. Using A or B, select either Digital key or Wireless
key as required, then press ENTER.
Dig. Key n. 001
Digital key 001
4. Using A or B, select the required digital key, then
press ENTER.
Description
Digital key 001
5. Enter the digital key label (refer to "Editing a text" un-
der "Using the Keypad"), then press ENTER.
Digitalkey 001
Enabled _
KYO320
6. Using ON or OFF, respectively, enable or disable the
digital key concerned, then using A or B, select the Pa-
trol attribute.
Digital Key
Patrol
7. Using ON or OFF, respectively, enable or disable the
Patrol attribute for the digital key concerned, then using
C or D, select the Stop Partition Alarms.
Digital key
Stop part.alarmx
7a. Using ON or OFF, respectively, enable or disable
the Stop Partition Alarms for the digital key concerned
(refer to "Stop Partition Alarms") then, using C or D se-
lect the Del.tel.queue attribute.
Digital key
Del.tel.queue
8. Using ON or OFF, respectively, enable or disable the
Del.tel.queue attribute for the digital key concerned
(refer to"Delete Call queue on Disarming"), then using
C or D, select Stop panel alar.
Digital key
Stop panel alarm
9. Using ON or OFF, respectively, enable or disable the
Stop panel Alarms attribute (refer to "Stop Panel
Alarms"), then press ENTER.
Max Num. access
Always
10. Enter the number of times the digital key will be allo-
wed to access the system, then press ENTER. To allow
unlimited use, enter zero (0).
Ass.Timer n. ---
None
11. Using A or B, select the Timer which will control the
digital key (the bottom line will show the label of the se-
lected Timer), then press ENTER.
Partition
XXXXXXXX
12. Enable the Key on the relevant Partitions (refer to
"Enabling Partitions and A, B, C and D Mode" under
"Using the Keypad"), then press ENTER.
To program the wireless keys, go back to step 3, then
using A or B, select the Wireless keys option.
Key /Card
Wireless Key
4a. Press ENTER:
PROGRAM PANEL
001
001
001
-
001
1-8
27