Telephone Options; Dialler Mode Access; Answer Mode Access; User Code Pin (Personal Identification Number) - Bentel Security OmniaTAST-R User Manual

The optional OmniaVOX board will allow the Panel to manage incoming and outgoing telephone calls (DTMF
only).
7 User codes are available for Panel control via telephone. The installer can enable/disable User code options and parti-
tions----as per customer requirements.
There are two ways of accessing Panel control via telephone:
---- Dialler Mode Access (after receiving a Dialler call);
---- Answer mode access (after calling the Panel).
n Dialler mode access
The User can operate the Panel during a Dialler call, as follows.
#
Step 1 Enter the User code PIN then press
Step 2 Press the number key of the required option (refer to Commands from Telephone keypad).
+
If no key is pressed within the programmed timeout (30 seconds at default) the Panel will end the call.
Use the
n Answer mode access
The Answering machine Voice message must be recorded by the installer. The Answering machine option must
be enabled.
+
The Answering machine option can be enabled/disabled from the keypad (refer to Enable/Disable Answering
machine).
Incoming calls will be dealt with as follows.
Teleservice If the Teleservice option is enabled (refer to the Enable/Disable Teleservice), the Panel will:
enabled ----answer with an audible signal (high tone)
----wait 4 seconds then play the Voice message
#
Step 1 Enter the User code PIN then press
Step 2 Press the number key of the required option (refer to Commands from Telephone keypad).
+
If no key is pressed within the programmed timeout (30 seconds at default) the Panel will end the call.
Use the
Teleservice If the Teleservice option is disabled (refer to Enable/Disable Teleservice), the Panel will:
disabled ----answer with an audible signal (low tone)
----wait 4 seconds then play the Voice message
+
Do not enter the User code PIN during the 4 second pause.
#
Step 1 Enter the User code PIN then press
Step 2 Press the number key of the required option (refer to Commands from Telephone keypad).
+
If no key is pressed within the programmed timeout (30 seconds at default) the Panel will end the call.
Use the

User code PIN (Personal Identification Number)

Master codes can select/deselect the Active status of their Slave codes, and change their PINs. The User code
PIN allows access to Panel control via telephone.
+
If an invalid User code PIN is entered, or the requested option is not enabled for the User code in question the
Panel will emit an error beep.

TELEPHONE OPTIONS

#
key to Undo mistakes.
#
key to Undo mistakes.
#
key to Undo mistakes.
#
before the message ends, otherwise, the Panel will end the call.
#
before the message ends, otherwise, the Panel will end the call.
#
before the message ends, otherwise, the Panel will end the call.
TELEPHONE OPTIONS
15