Installer Pin - Bentel Security KYO 320 Installation Manual

Seconds
RemainingSec.150
The second line of display shows the remaining time to
record, so it is easy to check the message length.
8. Speak at about 20 cm from the microphone. The
message must be recorded within the message time.
Once you have finished recording the message, you
can either continue recording or go back to the Installer
menu by pressing ESC.
n Playback
To play the recorded messages:
3a. Press ENTER.
PLAY MESSAGE 01
Message 001
4a. Using A or B , select the message.
PLAY MESSAGE 02
Message 002
5a. Press ENTER
Seconds 002
Start play
6a. Press ENTER again.
The Voice board will playback the selected message (the
message length will be shown on the display). Once the
message has ended, you can either continue listening or,
go back to the step 2. of the procedure by pressing ESC.
n Delete
To delete all messages work carefully through the follo-
wing steps:
VOICE FUNCTIONS
Delete messages
3b. Press ENTER
Delete messages
Confirm?
ATTENTION: if press ENTER again, all the messages
will be deleted and then the procedure go back to step
2.

Installer PIN

The Installer PINs can access the INSTALLER MENU
and Teleservice. This Control panel manages 5 Instal-
ler codes: 196, 197, 198, 199 and 200. Installer code
200 has Father code status and is already Active at de-
10
180
fault, therefore, it can be used to change the PINs of all
the other Installer Codes, and also its own (0200 at de-
fault). Installer Codes 196, 197, 198 and 199 have Son
status, therefore, can change their own PINs only (re-
spectively 0196, 0197, 0198, 0199 at default).
The default Installer PINs should be changed for secu-
rity reasons. To change the Installer PINs, work
carefully through the following steps. From the Installer
menu:assistenza. Il PIN Installatore può essere modifi-
cato come descritto di seguito: dal menù installatore:
INSTALLER MENU
Event logger
1. Using A or B, select the Installer PIN option.
INSTALLER MENU
Installer PIN
2. Press ENTER.
+
NOTE: If you access the menu using Installer
Code 200 (PIN 0200 at default), you will go to step
3. If you access the menu using one of the other
Installer Codes (0196, 0197, 0198 or 0199 at defa-
ult), you will go to step 5.
Installer PIN
Code 196
3.Using A or B, select an Installer code then press
ENTER.
Code 196
Not active
4.Using ON or OFF, enable (Active) or disable (Not ac-
tive) the code concerned, then press ENTER.
+
ONLY code no. 200 can assign Active or Not acti-
ve status to the other Installer Codes
Enter new PIN
PIN: xxxxxx
5.Enter the new PIN, then press ENTER. This program-
ming field accepts 4, 5 or 6 digits.
+
NOTE: If you enter a PIN with less than 4 digits the
keypad will emit an audible error signal and wait for
a valid PIN.
Repeat new pin
pin: xxxxxx
6. Enter the new PIN again, then press ENTER. The
keypad will step back to the start of the procedure.
INSTALLER MENU
Installer PIN
KYO320