Led Keypads; Readers - Bentel Security KYO 320 Installation Manual

+
If you enable the Part. Fast View option, memory of
Partition Alarm and Tamper events will be signalled
by blinking on the respective character will blink.
Partition
XXXXXXXX
7. Assign the Keypad to the partitions (refer to "Ena-
bling Partitions and A, B, C and D Mode" under "Using
the Keypad"), then press ENTER.
QuickArm code---
None
8. Enter the ID number of the User Code to be used for
Fast Arming, then press ENTER. The bottom line of the
display will show the User Code label. To disable Fast
Arming, enter 000. The bottom line of the display will
show the word "None".
Display part
Partition
9. During standby status, the first eight positions on the
bottom line (indicated by numbers 1 through 8 on the
frontplate) will show the partition status.
Each keypad can be enabled on up to thirty-two parti-
tions, you can select the partitions that will be shown on
the display via the Displayed Partitions option.
+
The partitions must be selected in successive or-
der, therefore, if partition no. 5 is selected first, par-
titions 1 through 4 CANNOT be selected.
Using C or D, select the position , then, using A and B,
select the partition that will be shown (or "None").
View
None
10. Press ENTER to go back to step 3.
n LED Keypads
2. Press ENTER.
Keypad n.
LED Keypad
3. Using A or B, select the keypad to be configured,
then press ENTER.
Description
LED Keypad 001
4. Enter the Keypad label (refer to "Editing Texts") then
press ENTER:
LED Keypad 001
Enrolled
5. Press ON to enrol the keypad (Present), then press
ENTER.
18
1_8
1
001
1
001
001
To unenrol a Keypad (delete from the Configuration),
press OFF.
LED keypad n.001
Tamp./Al.Beep -
6. Press ON or OFF, respectively, to enable or disable
the option on the display, then press ENTER.
Part. 1_8
XXXXXXXX
7. Assign the Keypad to the partitions (refer to "Enabling
Partitions and A, B, C and D Mode" under "Using the
Keypad"), then press ENTER.
n Readers
This system supports up to 32 Readers.
From the Configuration menu:
Configuration

Readers

2. Press ENTER
Reader n. 001
Reader
3. Using A or B, select the required Reader then press
ENTER.
Description
Reader 001
4. Enter the Reader label (refer to "Editing a text" under
"Using the Keypad"), then press ENTER.
Reader 001
Present
5. Press ON, to enrol the Reader (Present), then press
ENTER.
To unenrol a Reader (delete from the Configuration),
press OFF.
6. Using A or B, select the operating mode of the Reader: 3
LED Monitor or 3 LED.
Reader 001
3 LED monitor
Readers can be used to manage the system (Arming,
Disarming, etc.), or to display the status of the Control
panel events.
If the 3 LED Monitor option is selected, the Reader will
be able to display the status of up to three events but will
be UNAVAILABLE for system management).
If the 3 LED option is selected, the Reader will be able
to manage the system (Arming, Arming Type A and
Type B, Disarming
6a. Press ENTER:
001
KYO320