Exiting The Installer Menu; Event Logger - Bentel Security KYO 320 Installation Manual

n Exiting the Installer menu
To exit the Installer menu, press ESC:
INSTALLER MENU
Confirm?
Press ENTER to confirm to exit the Installer menu. If
you press ESC you will be in the programming fase.
When you exit the Installer menu, only if the system has
a number of PREMIUM LCD and CLASSIKA LCD key-
pads greater than 5, the update strings fase follows.
+
If you exit the PROGRAMMING menu after chan-
ging the parameters of the Receiver or a wireless
key, the display may show the following message
PROG. WLS RECEIV
PLEASE WAIT
If the Control Panel has not programmed the Receiver, the
display will show the following message:
PROG. WLS RECEIV
ERROR
If this occurs, check that the Receiver is operating properly.
If you exit the PROGRAMMING menu the Control panel will:
Ø set the keypad to standby status;
Ø reset the zone cycle counter;
Ø clear the BPI, Tamper and False key/card warnings;
Ø ignore the open Main unit event (until after closure);
Ø restart the Call queue from the interrupted call.
+
The Control panel will generate a "Start Program-
ming" event each time you exit the INSTALLER
MENU (this event will be signalled on the G indica-
tor on the Keypads, and by the Start program.
message in View Trouble mode).
"Start Programming" events can be deleted by Active User
Codes only, via the Reset PC Prog. from the USER MENU.

Event logger

This command will allow you to view and print the
events in the Event Logger. The KYO 320 Event logger
can store up to 10,000 events. Events are stored in
chronological order —starting from the most recent
event.
Each event provides the following information:
Ø Ev. (Event number)
ØTYPE (e.g. Zone Alarm, Invalid Code, etc.)
Ø IDENT (e.g. Zone number, Partition, etc.)
ØAGENT (e.g. Keypad, Reader, etc.)
Ø ID.AGEN (e.g. User code, Card/Key, etc.)
ØTIME (Time and Date of the event)
From the Installer menu:
KYO320
INSTALLER MENU
Event logger
1. Using A or B, select the Event logger option, then
press ENTER.
EVENT LOGGER
from last..
To view all Events
Press the ENTER key to view all the Events in the Log-
ger —starting from the most recent (from last . . ).
Use A and B to scroll the Events.
Press D to view the Event details.
To view Events from a specific Date
Using A or B scroll for the following prompt:
EVENT LOGGER
starting from..
Press the ENTER key, the display will show the Date
prompt.
starting from..
27/08/2002
Enter the required Date (DD/MM/YYYY), then press the
ENTER key. Use A and B to scroll the Events.
Press D to view the Event details (see above).
Ev.00033
Viewing buffer
+
The display will show the details of each Event. For
example, Tamper Events show the TYPE and
TIME only.
To Print Events from a specific Date
EVENT LOGGER
Print from..
Using A or B, scroll for the following prompt:
+
You will not be able to select the Print from ... op-
tion if the Print Logger option is enabled (refer to
"Print Logger" under "Configuration" in the
"PROGRAM PANEL" section).
Press the ENTER key, the display will show the Date
prompt.
Print from.
27/08/2002
Enter all the digits of the required Date (DD/MM/YYYY),
then press the ENTER key. The Keypad will exit the
INSTALLER MENU, and the Printer will print the Events
starting from the entered date to the most recent.
KEYPAD OPERATIONS
TYPE
7