Yamaha 40 Installation Manual page 62

2
a
3
4
5
8.0 mm (0.31 in)
53
4. Adjust:
• Shift cable joint position
Adjustment steps:
• Set the shift lever 1 to the neutral posi-
tion.
• Align the center of the set pin 2 with the
mark a on the bracket.
• Adjust the position of the cable joint 3
until its hole aligns with the set pin.
• Install the clip 4, and then tighten the
locknut 5.
WARNING
The cable joint must be screwed in a
minimum of 8.0 mm (0.31 in).
5. Check:
• Shift operation
Unsmooth operation → Adjust.
Checking steps:
• Turn the throttle grip to the fully closed
position.
• Check the shift lever for smooth operation
by shifting the lever from neutral to forward
and reverse.
E