Data Transmission Delay Time Setting - Yaesu FTM-100DR Instruction Manual

4
Turn the DIAL to select a number in the list that you
would like to save a call sign to, then press
The character input screen will be displayed.
5
Turn the DIAL and select characters to enter the call
sign.
Please register the call sign as follows.
Tip For character entry, see "Input characters" in the basic
operating manual on (
∗∗∗∗∗∗-NN
∗: call sign (6 characters maximum)
NN: SSID (a number between 1 and 15 or nil)
6
Press .
The screen will return to the list of call signs and the registered call sign will be
displayed.
7
Press for one second or longer.
The display will return to the previous screen.

Data transmission delay time setting

The following preamble (data transmission delay time) can be set when sending APRS
data.
Start of transmission
1
Press for one second or longer.
The set-up menu will be displayed.
2
Turn the DIAL, select [10 APRS], then press
The menu list will be displayed.
3
Turn the DIAL, select [10 APRS TX DELAY], then
press .
The screen for setting the data transmission delay
time will be displayed.
4
Turn the DIAL to select the desired delay time.
The delay time can be selected from the following 9
steps.
1 100 ms / 2 150 ms / 3 200 ms / 4 250 ms /
5 300 ms / 6 400 ms / 7 500 ms / 8 750 ms / 9 1000 ms
Tip Factory default value: 4 250 ms
P. 20).
APRS beacon transmission content
Preamble
(data transmission delay time)
(factory shipping value: 250ms)
Hours
63
Using the APRS set-up menu
.
End of transmission
APRS data
.